Atlas Roswell Spray Foam InsulationAtlas Roswell Spray Foam Insulation(575) 363-2021

Leading Insulation Contractor in Roswell NM - A Cooler Upstairs and Fewer Drafts

Atlas Roswell Spray Foam Insulation handles attic insulation, spray foam and drafty rooms in Roswell, Artesia and the cities around them. We also pull out insulation soaked by flood water, so the new layer goes on clean and dry.

A worker in protective coveralls sprays foam insulation into wall cavities between exposed studs.

We insulate and air seal attics, walls and crawl spaces for homeowners, landlords and business owners in Roswell whose rooms run too hot or too cold.

Roswell sits in the Pecos Valley, below the southern tip of the Rockies, and it's the hub of Southeastern New Mexico. Most folks here know the Spring River Zoo and its parkland, the UFO museum downtown and the Roswell Museum, which is closed for now after the October 2024 flood. We're based here and work in houses all over town, from older homes with thin, settled attic insulation to newer ones with the ductwork running overhead.

The city's building code list puts Roswell in climate zone 3B, a warm, dry zone with a frost depth of just 12 inches and a light snow load. For insulation, that means most of our work here is keeping summer heat from soaking down through the attic and stopping winter wind from finding the gaps. Water still gets under houses here now and then, so if you're curious about the ground under yours, the city's online maps on its website cover flood zones and are a good place to start before I take a look at your crawl space.

  • Licensed and fully insured.
  • Free in-person estimates.
  • Expect a reply within 1 business day.

Why people in Roswell call usWe show you first.

Want to know what's going on in your attic? Send us a note or call (575) 363-2021.

  1. See it, then decide

    We show you what's going on in your attic, walls or crawl space and why each step matters. That way you can weigh any bid, ours included.

  2. Problems fixed first

    If we find a roof leak or old wiring, we point it out so it's fixed before anything new goes in. Fresh insulation over a problem only hides it.

  3. Respect for your home

    Our crew covers floors on the way to the attic and cleans up before leaving, because somebody lives here. We work around the boxes stored up there and put them back where we found them.

Insulation contractor services in Roswell, NM

Atlas Roswell Spray Foam Insulation is an insulation contractor in Roswell, NM, and we offer 16 services for attics, walls, crawl spaces, basements and commercial buildings. Most calls start with a hot upstairs, cold floors, a drafty room over the garage or a power bill that keeps climbing. The price mostly comes down to how big the space is, how easy it is to reach, whether old or wet insulation has to come out first and which material fits your house. The schedule turns on the same things, mostly how much removal and sealing the job needs, and your estimate gives you the figure for your own house.

  • Worker in protective coveralls and a respirator applies spray foam to an interior wall with a hose-fed spray gun.

    Spray foam insulation

    Spray foam goes on as a liquid and expands into the gaps, sealing air while it insulates, which suits attics with ductwork and odd-shaped spaces.

  • Loose-fill attic insulation covers the floor beneath exposed roof trusses and plywood sheathing.

    Attic insulation

    Hot upstairs all summer? We check how many inches are already in your attic, fix what's wrong, then add enough to even out the rooms below.

  • Blown-in attic insulation covers the floor around roof supports, with orange depth markers and a ruler showing 18 to 22 inches.

    Blown-in insulation

    Blown-in insulation is loose fill we blow through a hose, so it settles into corners and reaches full depth out at the edges, not just the middle.

  • Unfinished room with white spray foam filling the wall cavities between wooden studs and rafters.

    Home insulation

    Not sure where your house is losing heat? We look at the attic, walls and crawl space together and tell you which one to fix first.

  • Attic roof and walls coated in white foam above exposed wooden framing and a slatted floor.

    Insulation removal

    We vacuum out insulation that's been soaked, packed flat or filled with droppings, so the new layer doesn't sit on top of the same problem.

  • Blown-in insulation covers an attic floor beneath exposed wooden roof trusses, with a depth gauge and ventilation fan visible.

    Crawl space insulation

    Cold floors in winter usually start in the crawl space, and we insulate under the house so the rooms above feel warmer underfoot.

  • An unfinished room has pink-faced fiberglass batts between wall studs and across the ceiling, with three windows and exposed plywood flooring.

    Wall insulation

    Walls left open during a remodel get batts or foam before the drywall goes up, and closed walls in older houses can be filled without tearing them out.

  • Spray foam insulation coats the roof underside and wall cavities beneath exposed wooden rafters, with lights and wiring visible.

    Air sealing services

    Most drafts come through small gaps nobody sees, and air sealing closes them with caulk and foam so heated and cooled air stays in your rooms.

  • Fiberglass batts fill the walls of an unfinished room beside exposed ductwork and red and blue plumbing lines.

    Basement insulation

    We insulate basement walls and rim joists, the framing that sits on the foundation, so a basement you use stays closer to the rest of the house.

  • Closed-cell spray foam coats the sloped attic walls around exposed wooden supports, pipes, and ductwork.

    Closed-cell foam insulation

    Closed-cell foam is dense foam that blocks moisture and adds stiffness, a good fit for rim joists, metal buildings and spots where damp is a worry.

  • A worker in protective coveralls sprays foam insulation between exposed ceiling rafters.

    Open-cell foam insulation

    Open-cell foam is softer and lighter, costs less than closed-cell and quiets noise, so we use it in attic rooflines and inside walls where moisture isn't a concern.

  • Fiberglass batts fill the spaces between exposed wooden rafters in a close-up view of a pitched ceiling.

    Commercial insulation

    Shops, offices and rental buildings that run too hot or too cold get the same look-first approach, with insulation chosen for how the building is used.

  • A crawl space has a plastic vapor barrier covering the floor and support piers beneath shiny insulated ducts.

    Crawl space vapor barrier

    We lay heavy plastic over the dirt in your crawl space and seal the seams, so ground moisture stays down and doesn't soak into wood and insulation.

  • White insulation fills the sloped roof framing and walls of an unfinished attic with a bare plywood floor.

    Vapor barrier installation

    Worried about moisture getting into walls or floors? We install vapor barriers, sheets that slow moisture, on the side that keeps your framing and insulation dry.

  • Cream spray foam fills the roof bays between exposed wooden rafters, with electrical fixtures attached to the beams.

    Attic air sealing

    Before we add insulation upstairs, we seal around can lights, pipes, wires and the attic hatch, where your heated and cooled air slips into the attic.

  • Spray foam covers the roof behind exposed framing, wiring, and metal ventilation boxes.

    Retrofit insulation

    We bring older houses with thin or settled insulation up to date without a remodel, working from the attic, crawl space or small holes in the walls.

How a job goes with usFrom first call to walk-through.

  1. Call or send a note

    Call (575) 363-2021 or send the contact form, and we get back to you within one business day to set up a visit.

  2. I come out myself

    I look over your attic, walls or crawl space and take photos, then walk you through what I found, like how many inches are already up there.

  3. Your written estimate

    After you've seen the photos, I write up a free estimate with no obligation, so you can look it over and compare it with any other bid.

  4. Our crew does the work

    Once you say yes, our installers do the job, starting with any removal and air sealing so the new insulation goes into a clean, tight space.

  5. Walk-through and care

    Before we pack up, I go over the finished job with you, show you the depth and the sealed gaps, and tell you what to keep an eye on.

Insulation questions from Roswell homeownersWhat people ask first.

How much does insulation cost in Roswell, NM?

There's no honest number until I've seen your attic, walls or crawl space, because the same size house can need a quick top-up or a full cleanout. That's why the estimate is done on site, free and with no obligation, so you get a price for your own house.

Why is one insulation quote so much higher than another?

Usually the higher quote includes prep the lower one skips, like pulling out bad insulation, sealing gaps and keeping the eave vents clear. Insulation laid over open gaps around lights and pipes ends up fighting a draft, and buried eave vents can trap moisture in the framing. Ask every contractor, us included, exactly what happens before the new insulation goes in.

How long does it take to insulate an attic?

It depends on how big the attic is, how easy it is to get into and whether old insulation has to come out first, and I'll tell you what to expect for your job at the estimate. Foam jobs also have a re-entry time, the stretch before you, the kids and the pets can come back inside, and we go over that before we start.

Is Atlas Roswell Spray Foam Insulation licensed and insured?

Yes, we're licensed and fully insured. Ask to see proof of insurance at the estimate, and ask the same of anyone else you're comparing, because it protects you if something goes wrong on your property.

Do you remove old insulation before adding new insulation?

We take it out when it's been soaked, packed flat or fouled with droppings, because new insulation on top just keeps the problem in the house. Clean, dry insulation can usually stay, and we add over it once the gaps are sealed. I'll show you photos of which one you've got before we decide.

Do you guarantee your insulation work?

Yes, our work is backed by our satisfaction guarantee. If anything about the finished job bothers you, call me at (575) 363-2021, since I still answer the phone myself.

Is spray foam better than blown-in insulation for an attic?

Not always, and for a plain attic floor, sealing the gaps and topping up blown-in usually wins because it costs less and does the job. Foam costs more, but it seals air while it insulates, so it's worth it when your ductwork runs through the attic. We'll tell you which one fits your house after we've looked.

Do I need a permit to insulate my house in Roswell?

It depends on the job, so we check with the right city or state office for yours and go over what we learn at the estimate. The city's Building Inspection office issues building permits for renovations, remodels and additions, and electrical permits now go through the State of New Mexico until further notice. When your job needs a permit, we take care of it.

About Atlas Roswell Spray Foam Insulation

I started Atlas Roswell Spray Foam Insulation in 2013 after learning the trade as a helper on a small insulation crew, hauling bags, running the hose and asking a lot of questions. Today we're an insulation contractor based in Roswell, licensed and fully insured, with 16 services for homes, rentals and commercial buildings. I still answer the phone and come out to look at jobs myself, because I want the person writing your bid to know the work from the ground up. You can read more about how we got here.

Tell us what's going on in your house

We'll get back to you to set up a visit, and I'll come out myself to look things over and walk you through what I find before anything is written up.

Location
Roswell, NM 88203
Hours
Mon–Fri: 6 AM–10 PM, Sat–Sun: 7 AM–11 PM

Where we work

Atlas Roswell Spray Foam Insulation is based in Roswell, NM, and we work across the area. This site has pages for 2 cities, Roswell and Artesia, and we take jobs in other cities nearby too.

(575) 363-2021Request an estimate